|
Post by pidjones on May 1, 2015 17:21:33 GMT
10-10-2012 10-8-2012 71050 miles. Air filter, oil (Rotella blue jug), oil filter (Purolator). Oil drain plug was stripped (even with torque wrench) so I replaced it with a one-over sized self-tapping plug. It is now an 18mm head but I had a socket for it in an old set. Everything looked pretty good under the shelter, but I did tighten and re-route a little.
Sent from my LePanII
|
|
|
Post by pidjones on May 1, 2015 17:21:59 GMT
1-10-2013 1-3-2013 put on a new Michelin Alpin @ 73350. This one mounted by Honda of Knoxville.
|
|
|
Post by pidjones on May 1, 2015 17:22:21 GMT
5-12-2013 76250 miles 5-4-2013, Honda of Knoxville replaced the seat due to a 1" seam separation. Covered under the extended warranty. First use of the EW, only good until September.
Also, picked up a garage-mate. 1978 gl1000 basket case w/'75 engine. I figure it to be a 2-year project just to get it on the road!
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:22:47 GMT
6-11-2013 77475 miles. Rotella T blue jug and a Big Bike filter (thanks again to Closet Chef). Put the Utopia back on about 1k back -just prefer having it if Judy isn't back there. No juice in the drain, all looking good. Ready for SMRI!
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:23:10 GMT
6-27-2013 Just a bit over 78k, and I have a new 'Stone on order for the front. That's only ~9k out of it, but it has held the road well and I think I'll stay with them for their reliability. Recently had intermittent speedometer failure along with F1 light. Separated connector behind right radiator and reconnected. Haven't had the problem in a couple days since then. Hope that is it, or it shows itself before the EW is up!
|
|
|
Post by pidjones on May 1, 2015 17:23:41 GMT
8-2-2013 78800, took to Honda of Knoxville for occasional F1 light - speed sensor. They diagnosed, replaced the speed sensor and got it back to me in a week - no charge. Coming up on the last month of Extended Warranty! Thanks to the tech, and Ronnie and Mike!
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:24:05 GMT
10-9-2013 81895 miles. Rotella 5W40 blue jug, Pureolator L14612 filter. No moisture in the drain.
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:24:43 GMT
4-17-2014 Valve check #2
84935 miles 4-7-2014 Rotella Blue jug 5W40 K&N PS 1010 oil filter ~1/4 oz oil&water in drain Did valve clearance check as follows: Cyl _ I _ E 1 ~5.5 _9 2 _ 5 __ 9 3 _ 5 __ 9 4 ~5.5 _9 5 _ 5t _ 9 6 _ 5t _ 9 t=tight.
6-20-2014 shim measurements Intake metric inch Exhaust metric inch 1 _ NM _ NM _ _ 210 .0827 2 _ 218 .0859 _ 216 .0852 3 _ 210 .0827 _ 198 .0780 4 _ 222 .0875 _ 218 .0855 5 _ 218 .0855 _ 196 .0768 6 _ 228 .0890 _ 210 .0825
I'll see if I can get Wimpy to do the shims on the back 2 cylinders when it gets too hot to ride this summer.
|
|
|
Post by pidjones on May 1, 2015 17:25:36 GMT
5-23-2014 5-23-2014 87622 miles. New 'stone on front, Dyna Beads. Touched up chips in rim powdercoat with model car enamel. Only about 9k on the front again, but I was wearing the wear bars!
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:26:04 GMT
6-19-2014 6-19-2014 88218 getting ready to change some valve shims. Checked cold compression, 210-215 on all cylinders. Cam chains slacked off, covers off, enough for tonight. Tomorrow the cams come off and I measure to order shims.
Sent from my LePanII using Tapatalk 2
|
|
|
Post by pidjones on May 1, 2015 17:26:40 GMT
6-20-2014 Shims on order
Couldn't swap any of them to get the right gap. Ordered from Partzilla: 14936 - 2.075 for #3 14938 - 2.125 for #5 14939 - 2.150 for #2 14943 - 2.250 for #6 all intakes
|
|
|
Post by pidjones on May 1, 2015 17:27:14 GMT
6-22-2014 While waiting for shims, installed the Bike Bike Parts trailer harness, but just tapped a rubber glove finger over the ends since I don't know what trailer wiring that I need to set up for yet. Anyway, the Kury hitch is on (installed about three months ago), the wiring harness on, the receiver has a ball and hitch pin - just need a trailer, now!
|
|
|
Post by pidjones on May 1, 2015 17:27:40 GMT
7-14-2014 6-30-2014 88218 Shims are in and installed, ready to hit the street.
|
|
|
Post by pidjones on May 1, 2015 17:28:05 GMT
7-14-2014 7-14-2014 New AP3 on order from Tire Rack. Getting over 16k on the last one, and she is nearing wear bars (but, sidewalls look OK).
|
|
|
Post by pidjones on May 1, 2015 17:28:24 GMT
8-14-2014 8-13-2014 Rotella Blue jug 15W40, Fram 6607 filter, QState 15W90 full synth outdrive (Api 5).
|
|